Installation; Choice Of Location; Permissible Ambient Conditions; Minimum Distances - Mennekes Basic 3,7 Manuel D'utilisation Et D'installation

5. Installation

The tasks described in this section may only be
carried out by a qualified electrician.
5.1

Choice of location

The device is solely intended for fixed floor mounting. A
suitable location meets the following requirements:
„ Technical data and mains data are the same.
Î "4. Technical Data"
„ Permitted environmental conditions are observed.
„ The minimum distances are respected.
„ The device and the charging station are in sufficient
proximity to each other, depending on the charging
cable used.
5.1.1

Permissible ambient conditions

T
DANGER
Danger of injury and fire
If the device is operated in potentially explosive atmos-
pheres (explosive area), explosive substances may ignite
due to sparking of components of the device.
f Do not use the device in potentially-explosive atmos-
pheres (e.g. at gas filling stations).
T
ATTENTION
Device damage due to unsuitable ambient conditions
Unsuitable ambient conditions can result in device dam-
age.
f Protect the device from a direct water jet.
f Do not install the device in flood-prone areas.
f Ensure adequate ventilation of the device. Do not install
in niches.
f Keep device away from heat sources.
f Avoid large temperature fluctuations.
Permissible ambient conditions
Ambient temperature
Average temperature
over 24 hours
Relative humidity

5.1.2 Minimum distances

T
ATTENTION
Damage to the device due to insufficient ventilation.
Insufficient ventilation can lead to overheating and thus to
damages to the device.
f Observe the specified minimum distances to other
objects (e.g. walls).
2 5
0
8 0 0
Fig. 5: Minimum distances [mm]
-25 °C ... +40 °C
< 35 °C
max. 95 % (non-condensing)
8 0 0
1 2
5 0
EN
9