Rinnai Q85SN Instructions D'installation Et D'entretien page 34

i
NOTICE
!
CAUTION
!
CAUTION
i
NOTICE
i
NOTICE
i
NOTICE
i
NOTICE
Item Description
Plastic Vent and/or air
pipes and fittings
Plastic Pipe cement and
primer
Item Description
Stainless steel vent
systems
Stainless steel vent
systems
Stainless steel vent
systems
Plastic Vent System
Plastic Vent System
Approval codes for installation of venting system
34
All manuals and user guides at all-guides.com
The termination shall be at least 4 feet (1,220 mm) for the US and 6 feet (1,830
mm) for Canada distance from electric meters, gas meters, regulators and
relief equipment. (for room air application only)
Horizontal vent systems should always be installed sloping towards the
boiler (min. 21 mm/m, 1/4 "/ feet), in order to avoid condensate retaining in
the vent system. With the condensate running back to the boiler the risk of
ice forming at the terminal is reduced.
The whole route of the vent system must be installed upwards, never
downwards, completely nor partly.
Place pipe supports every 4 feet (1,219 mm) of horizontal run, beginning with
support near the boiler to prevent movement in fittings and allow boiler to be
free from any strain or weight on boiler or fittings.
The terminal should be located where dispersal of combustion products is
not impeded and with due regard for the damage or discolouration that might
occur to building products in the vicinity (see fig 16 and 17).
In certain weather conditions condensation may also accumulate on the
outside of the air inlet pipe. Such conditions must be considered and where
necessary insulation of the inlet pipe may be required.
In cold and/or humid weather water vapor may condense on leaving the vent
terminal. The effect of such 'water condensation' must be considered.
The terminal must be located in a place not likely to cause a nuisance.
Use the Instructions of the Rinnai venting system for installation and service.
Cellular or Foam core PVC is not permitted for use with the boiler.
Flue Material United States
PVC Schedule 40 ANSI/ASTM D1785
PVC - DWV ANSI/ASTM D2665
CPVC Schedule 40 ANSI/ASTM F441
PVC ANSI/ASTM D2564
CPVC ANSI/ASTM F493
Flue Material Manufacturer
Stainless Steel Heat Fab
Stainless Steel Simpson Dura-Vent
Stainless Steel Ubbink
PPS Ubbink
PVC/CPVC IPEX
Approval Codes for Installation
Canada
ULC S636
Approval code
US/CAN
concentric
UL1738 twin pipe
UL1738 Flexible liner
ULC S636
Flue system
Saf-T Vent SC
Saf-T Vent EZ Seal
FastNSeal Flex
Rolux Condensing
Vent System
Rolux Condensing
Vent System
System 636
table 7