Heat Pump Location; Location And Connection - Astralpool PROELYXP07i Manuel D'installation Et D'utilisation

ATTENTION:
Please observe the following rules when installing the heat pump:
1.
Any addition of chemicals must take place in the piping located downstream from the heat
pump.
2.
Always keep the heat pump upright. If the unit has been held at an angle, wait at least 24
hours before applying mains power to the heat pump.

5.1 Heat pump location

The unit will work properly in any desired location as long as the following three items are present:
The unit may be installed in virtually any outdoor location as long as the specified minimum distances to other
objects are maintained (see drawing below). Please consult your installer for installation with an indoor pool.
Installation in a windy location does not present any problem at all.
ATTENTION: Never install the unit in a closed room with a limited air volume in which the air expelled
from the unit will be reused, or close to shrubbery that could block the air inlet. Such locations impair
the continuous supply of fresh air, resulting in reduced efficiency and possibly preventing sufficient heat
output.
5. Location and
5. 5. Location Location and and
1. Fresh air
2. Electricity
3. Swimming pool filters
- 20 -
connection
connection connection