Publicité
Les langues disponibles
Les langues disponibles
WATER DRAINAGE METHOD
When there is an excess of condensation water in the unit, the appliance will stop operating and displays
FULL TANK as mentioned below in the TROUBLESHOOTING section). This indicates that the condensation water needs to be
drained by carrying out the following procedures:
Manual drainage (Fig. 14)
The water must be drained into an area adapted for this purpose.
1.
Unplug the unit from the power supply.
2.
Place an appropriate recipient close to the drainage cap. (Fig. 14)
3.
Remove the drainage cap.
4.
The water needs to be drained and collected in a recipient (not supplied).
5. Once the water has been drained, replace the drainage cap firmly.
6.
Switch the unit on.
Fig. 14
Continuous drainage (Fig. 15)
When using the air-conditioning unit in dehumidification mode, continuous drainage is recommended
1.
Unplug the appliance from the power supply.
2.
Remove the drainage cap. While doing this, some water may come out, so make sure you have an appropriate recipient to
collect it in.
3. Connect the 2m drainage pipe (18). See fig. 15.
4.
The water can be continuously drained into a drain, a bucket or a sink using the pipe.
5.
Switch the appliance on.
Fig. 15
44
Manual_Snowair9HE-9HEP-12HE-12HEP_2021.indd 44
Manual_Snowair9HE-9HEP-12HE-12HEP_2021.indd 44
FR
EN
NOTE
Please
not dra
(which means
A
In orde
• Clos
perm
• Prot
cool
• Neve
• Neve
• Ensu
• Neve
• Neve
• Ensu
18
FOR M
Fig. 2
25/01/21 11:39
25/01/21 11:39
Publicité
