Télécharger Imprimer la page

Electro Depot Valberg 15S39 D S701T Consignes D'utilisation page 7

Publicité

Les langues disponibles

Les langues disponibles

B
Using the appliance
Before using the appliance
Preparing your dishwasher for its first use
• Make sure that the electrical and water supply specifications correspond to the values
indicated in the installation instructions for the appliance.
• Remove all packing materials from inside the appliance.
• Set the water softener level.
• Fill the container with rinse aid.
Using salt
To work properly, the dishwasher needs soft water, i.e. with less limescale. Otherwise, white
lime residue will remain on dishes and interior equipment. This will have a negative impact on
the washing, drying and shining performance of your appliance. As the water flows through the
softener, the ions that form the hydrometry are removed from the water; it therefore obtains
the softness level required for an optimal washing result. Depending on the water content
of the incoming water, these water-hardening ions quickly accumulate in the softener. The
water softener should be refreshed so that it maintains the same performance during the
next wash cycle. Use dishwasher salt for this purpose.
Please use only special dishwasher salt to soften the water in the machine. Do not use table
salt or powdered salt that dissolves easily in water. Using any other type of salt may damage
your machine.
10
EN
B
Using the appliance
Filling the compartment (IF APPLICABLE)
To add softening salt, open the salt compartment cover by turning it clockwise.
using for the first time, put 1 kg of salt and water
4
overflows. If possible, use the funnel
for easier filling. Replace the cover and close it. After
every 20 to 30 cycles, add salt to your appliance until it is full (about 1 kg).
Add salt to the salt compartment only when using it for the first time.
Use softening salt made for use in dishwashers.
When you start the dishwasher, the salt compartment fills with water. Therefore, you should
put the softening salt into the appliance before starting it.
If you do not start your appliance immediately after the softening salt has overflowed, run a
short washing programme to stop corrosion.
11
1 2
When
3
into the compartment until it almost
EN

Publicité

loading

Ce manuel est également adapté pour:

966547