Publicité
Les langues disponibles
Les langues disponibles
B
Using the appliance
Water inlet hose
Never use the water inlet hose from your old dishwasher. Use the new
hose supplied with your dishwasher. Before connecting the new or
water inlet hose, or one that has not been used for a long time, to your
dishwasher, run water through it for a while. Connect the water inlet
hose directly to the water inlet tap by hand. The pressure at the valve
must be minimum 0.03 Mpa and maximum 1 Mpa. If the water pressure
is higher than 1 MPa, install a pressure reducing device between the
tap and the hose.
Once the connections are made, open the valve completely and check that there are no leaks.
For the safety of your dishwasher, always close the inlet tap after each programme.
Check the marking on the water inlet hose!
If the models are marked with 25°, the water temperature may be at the maximum. 25°C
(cold water)
For all other models:
Preferably cold water; hot water max. temperature 60°C.
N.B.: Some models use an Aquastop system. If your dishwasher
is equipped with this system, there is a dangerous voltage.
Never cut the Aquastop nozzle and make sure that it is not
bent or twisted.
6
EN
B
Using the appliance
Drain hose
The drain hose can be connected either directly to a fixed drain
or to the special connection under the sink. Using a special
elbow pipe (if available), the dishwasher can be emptied directly
into the sink by hanging the elbow pipe on the edge of the sink.
This connection must be at least 50 cm and no more than 110
cm above ground level.
Warning
When a drain hose longer than 4 m is used, the utensils may remain dirty.
In this case, our company will not accept any responsibility.
0.5 - 1.1 m
Power supply connection
The earthed socket of your dishwasher must be connected to an earthed socket with the
correct voltage and current (in accordance with current standards). If your home does not have
an earthed installation, have this installed by a qualified electrician. In case of use without
earthing, our company will not be liable for any loss of use that may occur.
The plug of this appliance may have a 13 A fuse depending on the country. (e.g. the UK.) (e.g.
the UK, Saoudi Arabia)
Your dishwasher is configured to operate on 220-240 V. If your home is 110 V, insert a 110/220
V - 3,000 W transformer. The dishwasher must be unplugged during positioning.
Always use the covered plug supplied with the appliance. At low voltage, your dishwasher is
less efficient.
If the power cable is damaged, it must be replaced by the manufacturer, its after-sales
department or a similarly qualified person to avoid any danger. Otherwise, accidents may
happen.
min 4 cm
0.5 - 1.1 m
7
EN
Publicité
