Publicité
Les langues disponibles
Les langues disponibles
6. Flip the engine switch to the "RUN"(l) position.
7. Push the battery power restore switch for about
3 seconds and then release.
8. Pull the choke lever out to the "CHOKE" position.
9. Press and hold the engine switch in the "START"(ll)
position for few seconds and release the switch to the
"RUN"(l) position.
10. Push the choke button to the "RUN" position.
11. Allow generator to run at no load for few
minutes upon each initial start-up to permit
engine and generator to stablize.
NOTE:
The gasoline valve is OPEN, w
selector switch is in "GAS"position(4:30 o'clock).
To close this valve, turn the slector switch to the
" LPG" position (1.30 o'clock).
English
All manuals and user guides at all-guides.com
Starting the Generator (Electric Start-LPG)
NOTE: The generator will NOT start with LPG without
battery power or an appropriate connection.
1. Before starting the generator, check for loose
2. Check oil level.
3. Connect the regulator(A) to both LPG cylinder
and generator. Connect the power cord(B) to the
LPG regulator port. See "Connecting liquid
Petroleum Gas(LPG/Propane)
on page 13,14 and 15.
Use your fingers, slide the outer barrel back on
the LPG quick connect hose fitting. While the outer
barrel is in the back position, insert the LPG hose
(included) into the inlet and release the outer barrel.
The barrel will automatically return and lock the
hose in the inlet.
4. Fully open the LPG cylinder knob.
5. Turn the fuel selector switch to "LPG" position(1:30 o'clock).
hen the fuel
Page 22
or missing parts and for any damage which
may have occurred during shipment.
Customer Service: 1-844-FIRMAN1
Cylinder
" section
Publicité
