Publicité
Les langues disponibles
Les langues disponibles
Remote control
Inserting Batteries
1
Open the battery
compartment cover in the
direction of the arrow.
Battery precautions
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device. To avoid a potential short circuit, insert the "–" end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer's directions.)
Remote control basics
• Press POWER to turn the unit on or off.
• Select your desired operating mode (TV/VCR or DVD) using TV/VCR or DVD.
• Press CH +/– to move through the channels one channel at a time.
• The Arrow buttons (
• You can directly access specific channels using the number buttons.
Operation
• Aim the remote control at the remote sensor and press control
buttons to operate.
• Operate the remote control within 30° angle on either side of the
remote sensor, up to a distance of Approx. 5 meters.
10
All manuals and user guides at all-guides.com
2
Install two "AAA" batteries ( not
supplied), paying attention to the
polarity diagram in the battery
compartment.
/
/
/
) are also used to navigate on-screen menu system.
(continued)
3
Replace the compartment
cover.
Approx. 5 meters
Publicité
