CAME EDGH 44X49 Instructions D'assemblage Et De Montage page 14

4.3 Mounting the contact profile onto the mounting profile
Fit the first side of the
1
contact profile flush at both
ends of the mounting profile
and apply uniform pressure
to press it into the mounting
profile, working from the
ends towards the centre.
Tip: In case of limited accessibility, the first side of the contact profile can be fitted into the mounting profile prior to fixing the mounting profile.
This can be helpful for example at folding or swing gates, when safety edges are mounted near the ground.
3
14
The rubber retainers must engage fully in the mounting
2
profile.
Tip: Use a suitable tool, for example a wide spatula, for
pressing in.
Push on the profile hard from the front to check
4
that it has been pressed in correctly. The contact
profile must not come away from the
mounting profile at any point.
✓
✓ ✗