CAME EDGH 44X49 Instructions D'assemblage Et De Montage page 11

3.4 Assembly of contact profiles
1. Cutting the contact profile to length
1
= total length of the sensor
L
total
2
2. Mounting contact end pieces
2
Hold the profile shank at an acute angle and check for
axial alignment when pressing the contact end piece in.
Contact end pieces can only be mounted and used once. Reliable contacting and sealing are not guaranteed during disassembly
and re-assembly!
L = L – 24 mm
contact profile
total
3
1
The sealant is highly adhesive; dust and dirt particles will stick
to it immediately on contact. Therefore, once you have unpacked
a contact end piece and removed the protective cover, you
should proceed with particular care and ensure that the working
environment is kept clean and tidy until it is pressed into place.
3
The sealant should overflow all the way round the sealing
edge.
✓
✗
11