Publicité
Les langues disponibles
Les langues disponibles
armrest, as shown in the pictures. Route the lap belt under both armrests.
5. Place shoulder portion into the upper belt guide on the headrest so that belt lays
properly across child: on the collar bone, interior (A) to the shoulder (B).
6. Fasten the vehicle seat belt. You will hear an audible CLICK! Pull the seat belt tight to
make sure it is not twisted.
7.
Make sure seat belt is not twisted and remove slack from seatbelt so it lays flat, smooth
and snug across child in all locations.
CLICK
NOTE: Test by pulling on the child restraint and shoulder belt to ensure it is locked.
GROUP III (22-36 KG)
NOTE: When using this child restraint in group III,
remove the backrest. Please refer to ASSEMBLING AND
DISASSEMBLING THE CHILD RESTRAINT paragraph.
1.
Place booster seat forward-facing (in the direction of
travel) in proper seating location, flat on the vehicle
seat bottom.
2. Press the ISOFIX button to pull out the two ISOFIX locking arms from the base bottom.
You will hear an audible CLICK!
means ISOFIX attachments are unlocked.
NOTE: The ISOFIX attachment points are located between the surface and the backrest
of the vehicle seat.
3. Align ISOFIX attachments to the metal anchorages at the bottom of the car seat's
backrest and push it until it clicks.
of the ISOFIX locking arms turn into green safety colour.
CAUTION: After the ISOFIX installation check if the child restraint is securely fitted. If the
child restraint is not stable and is shaking, reinstall.
4. To fasten seat belt across child: lap portion of the vehicle seat belt should rest within
both lower belt guides with buckle located on the outside of the child restraint. Vehicle
shoulder belt must be routed above the armrest, lap belt must be routed under both
armrests.
5. Place shoulder portion so that belt lays properly across child: on the collar bone,
interior (A) to the shoulder (B).
6. Fasten the vehicle seat belt. You will hear an audible CLICK! Pull the seat belt tight to
make sure it is not twisted.
7.
Make sure seat belt is not twisted and remove slack from seatbelt so it lays flat, smooth
and snug across child in all locations.
CLICK
Ensure that the indicator turns into a red colour, which
You will hear an audible CLICK! Ensure the both sides
A
A
B
B
picture a
EN
41
Publicité
