Pushing The Appliance Into The Installation Niche - Gaggenau RB 492 Instructions D'installation

1. Pushing the appliance into
the installation niche
ã
CAUTION
Caution when pushing the appliance into the
installation niche. Do not damage the water line or
power cord.
Note:
When the floor or the appliance is not leveled in
comparison to the installation niche adjust height
adjustable wheels before you move the appliance into
the installation niche.
1. Remove the base panel.
2. Raise the height-adjustable wheels at the back
3
by approx. / " (10 mm).
8
3. Put the electric plug into the socket.
4. Push the water line into the guard tube (a) at the rear
of the appliance.
ã
WARNING
The appliance may tilt when the water connection
line is inserted into the protective pipe (a)!
16
5. Prevent the power cord from becoming caught.
Tie a piece of string to the middle of the power cord
and feed forwards over the top of the appliance.
When pushing in the appliance, pull the cable
upwards. Take care not to pinch the power cord.
or
Using adhesive tape, tape the power cord to the
floor centrally behind the appliance approx.
15" (380 mm) away from the rear panel of
the installation niche.
6. Carefully push the appliance into the installation
niche.
7. Remove edge protection (if attached).