hestan KICS 36 Manuel D'installation page 9

COOKTOP INSTALLATION
STEP 2
Place a towel or cloth on the work surface. Place the cooktop face down on the protected area.
Step 3
A foam tape is provided to seal the cooktop to the countertop. Apply tape to the underside of the
cooktop glass between the body of the cooktop and the inner edge of the frame.
There should be about .08" [2mm] between the edge of the tape and the edge of the glass. Use tape
around the entire glass perimeter.
The tape will retain the cooktop and seal against leaks into the cabinet.
they meet with no gaps.
COOKTOP GLASS
Figure 7. Apply foam tape
STEP 4
Make a final check that all required clearances are met.
Feed the cable through the cabinet as needed. Insert the cooktop centered into the cutout opening.
Make sure the front edge of the counter top is parallel to the cooktop.
Figure 8. Placing cooktop
All manuals and user guides at all-guides.com
(CONT.)
COOKTOP HOUSING
GLASS FRAME
Trim the tape ends so that
FOAM
TAPE
2 mm
©2018 Hestan Commercial Corporation
EN
7