BorMann PRO BBP3980 Manuel D'instructions page 9

EN
1. Guide bar cover 2. Safety guard
XIII. Removing or installing saw chain
The saw chain and the guide bar are still hot just after the operation. Let them cool down enough before carrying out any work on the tool.
To remove the saw chain, perform the following steps:
1. Pull the lever up while pressing its edge. (Fig.7)
2. Turn the lever anticlockwise until the sprocket cover comes off. (Fig.8)
3. Remove the sprocket cover then remove the saw chain and guide bar from the chain saw body.(Fig.9)
1. Lever 2. Sprocket cover
To install the saw chain, perform the following steps (Fig.10) :
1. Make sure the direction of the chain. The mark on the
chain shows the direction of the chain. Attach the saw chain
onto the guide bar.
2. Fit in one end of the saw chain on the top of the guide bar
and the other end around the sprocket.
3. Rest the guide bar in original place on the chain saw.
9
(Fig.5)
(Fig.7)
(Fig.8)
WWW.NIKOLAOUTOOLS.GR
1. Chain saw body 2. Saw chain 3. Guide bar 4. Sprocket cover
(Fig.10)
1. Mark 2. Sprocket
(Fig.6)
(Fig.9)