BorMann PRO BBP3980 Manuel D'instructions page 6

EN
17. Do not start the chain saw with the chain cover being installed on it. Starting the chain saw with the chain cover being installed on it may cause the chain
cover to thrown out forward resulting in personal injury and damage to objects around the operator.
18. Avoid dangerous environment. Don't use the tool in damp or wet locations or expose it to rain. Water entering the tool will increase the risk of electric
shock.
19. Do not dispose of the battery(ies) in a fire. The cell may explode. Check with local codes for possible special disposal instructions.
20. Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.
21. Do not charge battery in rain, or in wet locations.
WARNING:
DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE
or failure to follow the safety rules stated in this instruction manual may cause serious personal injury.
IV. Important safety instructions for battery cartridge
1. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion.
4. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any conductive material.
(2) Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc.
(3) Do not expose battery cartridge to water or rain.
A battery short can cause a large current flow, overheating, possible burns and even a breakdown.
6. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 °C (122 °F).
7. Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The battery cartridge can explode in a fire.
8. Be careful not to drop or strike battery.
9. Do not use a damaged battery.
10. The contained lithium-ion batteries are subject to the Dangerous Goods Legislation requirements. For commercial transports e.g. by third parties, forward-
ing agents, special requirement on packaging and labelling must be observed. For preparation of the item being shipped, consulting an expert for hazardous
material is required. Please also observe possibly more detailed national regulations. Tape or mask off open contacts and pack up the battery in such a manner
that it cannot move around in the packaging.
11. Follow your local regulations relating to disposal of battery.
12. Use the batteries only with the appropriate BORMANN products. Installing the batteries to non-compliant products may result in a fire, excessive heat,
explosion, or leak of electrolyte.
Use only the respective genuine BORMANN batteries. The use of inappropriate batteries, or batteries that have been altered, may result in the
battery bursting causing fires, personal injury and damage. It will also void the warranty for the said BORMANN tool and charger.
Tips for maintaining maximum battery life
1. Charge the battery cartridge before completely discharged. Always stop tool operation and charge the battery cartridge when you notice less tool power.
2. Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life.
3. Charge the battery cartridge with room temperature at 5 °C - 45 °C. Let a hot battery cartridge cool down before charging it.
4. Charge the battery cartridge if you do not use it for a long period (more than six months).
Functional description
Always be sure that the tool is switched off and the battery cartridge
is removed before adjusting or checking function on the tool.
6
WWW.NIKOLAOUTOOLS.GR