BorMann PRO BBP3980 Manuel D'instructions page 13

EN
XXII. Replacing the sprocket
A worn sprocket will damage a new saw chain. Have the sprocket replaced in this case.
Before fitting a new saw chain, check the condition of the sprocket.
Always fit a new locking ring when replacing the sprocket.
(Fig.22-23-24)
1. Locking ring 2. Sprocket
XXIII. Storing the tool
1. Clean the tool before storing. Remove any chips and sawdust from the tool after removing the sprocket cover.
2.After cleaning the tool, run it under no load to lubricate the saw chain and guide bar.
3.Cover the guide bar with the guide bar cover.
XXIV. Optional accessories
These accessories or attachments are recommended for use with the tool specified in this manual. The use of any other accessories or
attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local BORMANN TOOLS Service Center.
•Saw chain
•Guide bar
•Guide bar cover
•Lubricating Oil
•BORMANN genuine battery and charger
WARNING:
If you purchase a guide bar of different length from the standard guide bar, also purchase a suitable guide bar cover together. It must fit
and fully cover the guide bar on the chain saw.
NOTICE:
Some items in the list may be included in the tool package as standard
accessories. They may differ from country to country.
13
(Fig.22)
NOTICE:
Make sure that the sprocket is installed as shown in the figure.
(Fig.24)
WWW.NIKOLAOUTOOLS.GR
1. Sprocket 2. Areas to be worn out
(Fig.23)