BorMann PRO BBP3980 Manuel D'instructions page 11

EN
XV. Before use
Lubricating Oil
Only use commercially available, biodegradable chain oils. Do not use engine oil, waste oil or other mineral oils.
The saw chain suggest to refuel every time before using. To apply machine oil
onto the saw chain, perform the following steps:
Note: for steps 1-2, refer to 1-2 steps of "Remove the saw chain"
3. Use an oiler(machine oil bottle) to oil the saw chain and the sprocket. (Fig.16)
Note: for steps 4-5, refer to 4-5 steps of "Install the saw chain"
NOTICE:
• Always fill the right amount of lubricating oil each time. Avoid too much or too
little.
• If the saw makes a rattling noise, the saw chain must be lubricated.
XVI. Operation
• Never remove the safety guard while operating. There is a risk of injury!
• Never reach over the safety guard or under the limit stop. There is a risk of injury!
• Do not cut if the saw chain is in contact with the workpiece, is in the workpiece or may hit an object. This can lead to serious injuries.
• Clamp loose workpieces before cutting them. Remove foreign objects such as nails, screws, etc.
• Keep all parts of the body away from the saw chain when the motor is operating.
• Hold the chain saw firmly with both hands when the motor is running.
• Do not overreach. Keep proper footing and balance at all times.
• When cutting a branch that is under tension be alert for spring back. When the tension in the wood fibres is released, the spring-loaded limb
may strike the operator and/or throw the chain saw out of control.
• Use extreme caution when cutting brush and saplings. The slender material may catch the saw chain and be whipped toward you or pull you
off balance.
NOTICE:
• Never toss or drop the tool.
• Do not cover the ventilation slots of the tool.
Bring the limit stop of the chain saw body into contact with the surface of the
work piece to be cut before switching on. Otherwise it may cause the guide
bar to wobble, resulting in injury to operator. Saw the work piece to be cut by
just moving it down by applying only light pressure to the chain saw and the
chain speed should not be much slower.
If you cannot cut the work piece right through with a single stroke: Apply light
pressure to the handle and continue sawing and draw the chain saw back a
little; then finish the cut. (Fig.17-18)
11
(Fig.16)
WWW.NIKOLAOUTOOLS.GR
1. Oiler (Machine Oil bottle)
1. Limit stop 2. Grip surface 3. Ventilation slots
(Fig.17)
(Fig.18)