JVC KD-SH77 Manuel D'instructions page 8

RADIO BASIC OPERATIONS
Listening to the radio
You can use either automatic searching or
manual searching to tune into a particular station.
Searching a station automatically:
Auto search
1
Select the band (FM1 – 3, AM).
FM 1
Selected band appears.
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to
an FM broadcast.
2
Start searching a station.
When a station is received, searching stops.
8
EN08-10.KD-SH77_55[J]f
1 Press SOURCE
repeatedly to select the
tuner as the source.
2 If necessary, press
BAND (B) repeatedly to
select FM or AM. Each
time you press the
button, the band changes
as follows:
FM 2 FM 3 AM
Press ¢
to search
stations of higher
frequencies.
4 to search
Press
stations of lower
frequencies.
8
To stop searching before a station is received,
press the same button you have pressed for
searching.
To turn in FM stations only with strong signals
1 Press MODE (M) to enter the functions mode
while listening to an FM broadcast.
2 Press LO (local) while still in the functions
mode, so that the LOCAL indicator lights up on
the display.
This function works only while searching FM
stations, including SSM preset.
Each time you press the button, the LOCAL
indicator lights up and goes off alternately.
Searching a station manually:
Manual search
1
Select the band (FM1 – 3, AM).
1 Press SOURCE
2 If necessary, press
FM 1 FM 2
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to
an FM broadcast.
01.1.9, 4:31 PM
repeatedly to select tuner
as the source.
BAND (B) repeatedly to
select FM or AM. Each
time you press the
button, the band
changes as follows:
FM 3 AM