JVC KD-SH77 Manuel D'instructions page 25

When connecting a DVD player:
: Turns on and off the power.
3:
Starts playback.
¡:
• Fast-forward the track when pressed and
held.
• Skip to the beginning of the next tracks
when pressed briefly.
1:
• Reverses the track when pressed and
held.
• Go back to the beginning of the current
track when pressed briefly.
Go back to the beginning of the previous
tracks when pressed consecutively.
7:
Stops playback.
Note:
When you press the above buttons, the display shows
"DVD" and its operation mode (such as 3, 7 ).
When connecting a VCR:
: Turns on and off the power.
3:
Starts playback.
¡:
Fast-winds a tape when pressed and held.
1:
Rewinds a tape when pressed and held.
7:
Stops playback.
Note:
When you press the above buttons, the display shows
"VCR" and its operation mode (such as 3, 7 ).
For KD-SH55:
You can connect two external components to this
unit.
Connect one to the MP3 INPUT jack on the
control panel, and the other to the CD changer
jack on the rear.
Before operating the external component
connected to the CD changer jack, select
the external input correctly. (See "To select
the external component to use – EXT INPUT"
on page 20.)
If the input level of the external
component connected to the MP3 INPUT
jack is not high enough, increase the input
level properly.
Without adjusting the input level, you may be
surprised at a loud sound when you change
the source from the external component to
another. (See "To adjust the auxiliary input
level – AUX ADJ" on page 20.)
EN24-25.KD-SH77_55[J]f
1
2
25
Select the external component (AUX
INPUT or LINE INPUT).
When you select a source,
the power automatically
comes on.
Each time you press the
button, the source changes
as described on page 7.
AUX INPUT: To select the component
connected to the MP3 INPUT
jack on the control panel
LINE INPUT: To select the component
connected to the CD changer
jack
• If "LINE INPUT" cannot be selected, see
page 20 and select the external input ("LINE
INPUT"). This cannot be used together with
the CD changer.
Turn on the connected component
and start playing the source.
01.1.9, 4:32 PM
25