Ribimex PRBAT20 Manuel D'instructions Et D'utilisation page 20

4.3- Presentation
The multifunction tool is delivered pre-assembled.
Only the accessories require user's assembly intervention.
4.4- Charge the battery
Use only the chargers listed in the technical data. Only these chargers are suitable
for the lithium-ion battery of your power tool.
The supplied battery is partially charged. To ensure full battery capacity, fully
charge the battery in the battery charger before using your power tool for the first
time.
1. Insert the battery on the charger all the way in (Fig. 1 & 2).
2. To remove, press the release button and remove the battery from the charger. Do not exert any
force (Fig. 3).
The lithium-ion battery can be charged at any time without reducing its lifetime. Interruption of the
charging procedure does not damage the battery.
4.5- Assembly of work accessories
Before working on the product (maintenance, changing of accessories) and during
transport or storage, make sure that the product is disconnected from its power
source (battery removed).
Wear protective gloves to change accessories.
If necessary, remove the work attachment already mounted on the support, pulling the clamping tab
all the way to the end (Fig. 4 & 5).
4.6- Mounting / replacement of accessories
1. Pull the locking tab all the way out (Fig. 6).
2. Place the desired accessory in the centre of the 6-pin drive plate (Fig. 7).
3. Close the locking tab (Fig. 8).
All manuals and user guides at all-guides.com
Fig. 1 Fig. 2
Fig. 4
Fig. 3
Fig. 5
Page 20 / 34