Ribimex PRBAT20 Manuel D'instructions Et D'utilisation page 19

The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above.
8. WARNING
Do not assume of your knowledge of the tool.
Remember that a split second of negligence is sufficient to cause serious injury and/or damage.
9. Special Instructions
- Do not use accessories / blades chipped, torn or damaged.
- An accessory / blade that is already damaged or deformed should not be used thereafter.
Use only an original accessory / blade that is either delivered or recommended by the manufacturer.
10. Handling, transport and storage accessories / blades:
Accessories / blades are fragile and therefore susceptible to shocks and impacts.
Therefore, special precautions are necessary:
a) Do not drop the accessory / blade and avoid impacts.
b) Do not use an accessory / blade that has dropped to the ground or is otherwise damaged.
c) Avoid vibration or vibration during use.
d) Avoid damaging the bore
e) Avoid excessive loads on the cutting surface
f) Store the accessory / blade flat or perpendicular, and keep them dry, protected from frost and at a
constant temperature.
g) Keep accessories / blades in their original packaging or in special packaging and on shelves
3.5- In the event of emergency
Stop immediately the tool and unplug from mains.
Assist the injured person with first aid and call for medical assistance as quickly as possible.
3.6- Do NOT use the tool:
- For other uses that the one specified in this manual.
- When tired or under the influence of drugs, alcohol, or medication.
- In explosive atmosphere (e.g. in presence of flammable liquids, gas, dust ...)
- If the product is damaged or if not fully or securely assembled.
- If the switch is damaged and does not allow to stop the tool.
- If the tool is not working properly, has been dropped, damaged, or dropped into water, do not
attempt to repair it; bring it to your retailer for proper service, replacement or repair, or a person
with similar qualification to avoid any danger.
IV. GETTING STARTED
Before any intervention, ensure that product is unplugged from its main power
source.
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage.
4.2- Content
- 1 multifunction tool
- 1 cut saw blade
- 1 instructions manual
All manuals and user guides at all-guides.com
Page 19 / 34