Hansgrohe Solaris E 04169 0 Serie Instructions D'installation page 6

English
Install the drain
Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
Unscrew the tailpiece from the tee. Wrap the
threads with Teflon tape and replace.
Install the flexible sealing gasket on the
flange. Sit it in the sink outlet.
From below, install the black mack gasket, white
friction ring, and retainer nut to the flange. Do
not tighten the nut against the bottom of the sink
at this time.
Thread the tee and tailpiece to the flange. The
pivot must face the faucet. If necessary, turn the
drain assembly.
Tighten the retainer nut.
Sit the plunger assembly in the drain.
Install the horizontal rod through the pivot ball
seals and into the tee so that the end goes
through the loop in the bottom of the height ad-
juster. The two pivot ball seals should surround
the pivot ball.
Slide the link over end of pull rod. Tighten screw.
Slide one end of spring clip over end of horizon-
tal rod. Slide link over end of horizontal rod.
Test motion of drain plunger. Reposition link as
necessary. There are multiple holes in the link
-- the horizontal rod may go through any of the
holes.
When satisfied with the action of the drain, slide
the other end of the spring clip over the end of
the horizontal rod.
6
plunger
flange
sealing gasket
mack gasket
friction ring
retainer nut
horizontal
rod
pivot ball
pivot
tee
tailpiece
link
nut
pivot ball seals
spring clip