Publicité
Les langues disponibles
Les langues disponibles
STEP 1:
Move the engine On/Off switch to the
OFF position.
STEP 1:
If detergents have been used, insert suction
tube into 0.5 gallons (1.8 L) of fresh water.
Install the black detergent nozzle and siphon
water at low pressure for one minute to clean
any detergent residue in the system.
STEP 2:
Move the engine On/Off switch to the OFF
position.
STEP 3:
Turn off the water source.
STEP 4:
Press trigger to release water pressure.
It is highly recommended to use Kärcher's
Pump Guard (part number 9.558-998.0 sold
separately) before winter storage and during
the cleaning season to protect the pump from
freezing and premature wear.
STEP 1:
Move engine On/Off switch to OFF position.
STEP 2:
Disconnect all hoses.
STEP 3:
Unscrew cap from Pump Guard bottle.
STEP 4:
Remove internal seal.
STEP 5:
Reattach cap to Pump Guard bottle and
remove black protective cap.
12
TAKING A BREAK ...five minutes or more
SHUTTING DOWN & CLEAN-UP
WINTERIZING AND LONG-TERM STORAGE
STEP 2:
Release trigger and engage safety lock.
STEP 5:
Release trigger and engage gun safety lock.
STEP 6:
Disconnect the garden hose from the water
inlet on the unit.
STEP 7:
Disconnect the high pressure hose from the
high pressure outlet. Store the high pressure
hose in the hose holder strap.
STEP 6:
Screw bottle into water inlet on pressure
washer pump and squeeze until fluid starts
to exit tue pump
STEP 7:
Pull starter handle until fluid starts to exit the
pump's high pressure outlet
STEP 8:
Unscrew bottle. Store or dispose properly
CAUTION
Failure to follow the above directions may
result in damage to the pump assembly and
accessories and void the warranty.
.
Publicité
