Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Troubleshooting
Samsung works hard to ensure that you don't have problems with your new electric
range. If you run into unexpected trouble, look first for a solution in the tables below.
If, after trying the suggested solution, you're still having trouble, call Samsung at
1-800-SAMSUNG (1-800-726-7864).
Installation
Problem
Possible cause
The range is not
The appliance has been
level.
installed improperly.
The floor is sagging or
sloping.
The kitchen cabinets are
not properly aligned and
make the range appear to
be not level.
The appliance
The kitchen cabinets are
must be accessed
not square and too close to
for servicing and
the appliance.
cannot be moved
Carpet is interfering with
easily.
movement of the range.
All manuals and user guides at all-guides.com
CONTROL DISPLAY
Solution
COOKTOP
•
Place the oven rack in
the center of the oven.
Place a level on the
oven rack. Adjust the
leveling legs at the base
of the range until the
oven rack is level.
•
Insure the floor is level
and strong and stable
enough to adequately
support the range.
Contact a carpenter to
correct the situation.
Insure the cabinets are
square and provide
sufficient room for
installation.
Contact a builder or installer
to make the appliance
accessible.
Provide sufficient space so
the range can be lifted over
the carpet.
Problem
Possible cause
The display goes
A fuse in your home may be
blank.
blown or the circuit breaker
tripped.
The display flashes.
There was a power failure.
Problem
Possible cause
The surface units
You may be using
will not maintain
inappropriate cookware.
a rolling boil or
will not cook fast
In some areas, the power
enough.
(voltage) may be low.
The surface units
A fuse in your home may be
will not turn on.
blown or the circuit breaker
tripped.
The cooktop controls are set
improperly.
Areas of
Food spillover was not
discoloration on the
cleaned.
cooktop.
The surface is hot and the
model features a light-
colored cooktop.
Solution
Replace the fuse or reset the
circuit breaker.
Reset the clock.
Solution
Use pans which are flat and
match the diameter of the
surface unit selected.
Cover the pan with a lid until
the desired heat is obtained.
Replace the fuse or reset the
circuit breaker.
Check if the correct control is
set for the surface unit you
are using.
Refer to the section on the
care and cleaning of the glass
cooktop on pages 35-36.
This is normal. The surface
may appear discolored when
it is hot. This is temporary and
will disappear as the glass
cools.
English 39
Publicité
