Publicité
STEP 1
Attach (1) back bracket and (1) side
mount bracket to each slide using
(2) #8-32 flat head screws and (2)
lock nuts each (See Figure A).
STEP 2
Decide the height of the drawer
box and mark the inside left wall
of the cabinet near the front, fold
the template on the dotted line,
then align the top of the template
with the mark and tape it in place
(See Figure B).
A. Face frame cabinet – fold
the template on the dotted line
and place at the front of cabinet
against the back of the face
frame
B. Inset cabinet – set template
back the thickness of the door.
C. Frameless cabinet - align
the front of the template to the
front of the cabinet wall.
Note: Consider the height of the
products you want to store in the
bins and basket before marking
the desired height of the drawer.
STEP 3
Mark the (3) screw locations on
the cabinet wall (denoted by
center marks on the template) and
remove the template.
STEP 4
Place one of the remaining side
mount brackets on the inside wall,
aligning the holes to the marks,
and attach using (2) #8 x 5/8" truss
head screws (See Figure C).
Repeat steps 2-4 for the right wall.
#2
#2
#2
FIG. A
FIG. B
Template
FIG. C
Customer Service: 800-626-1126 | rev-a-shelf.com
2
Publicité
