Hendi 240502 Mode D'emploi page 5

Operation
• Fill the container with water only between the
MIN and MAX level.
• Connect the power plug with a suitable electri-
cal outlet. Make sure the electrical power supply
voltage rating corresponds with the power supply
details shown on the appliance rating label.
• Turn ON the appliance by pressing the green ON/
OFF switch.
Note:
• Only water can be poured into the container.
After use
• Turn OFF the appliance by pressing the green
ON/OFF switch.
• Unplug the appliance from the electrical outlet.
Cleaning and maintenance
• Always remove the plug from the socket before
cleaning the appliance.
• Beware: Never immerse the appliance in water
or any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• Never use aggressive cleaning agents or abra-
sives. Do not use any sharp or pointed objects.
Trouble Shooting
Problems
The appliance is plugged in, turned
on, the indicator lights up but the ap-
pliance does not heat up.
The appliance is plugged in, turned
on, the indicator lights up but heating
temperature is out of control.
The appliance is plugged in, turned
on, the indicator lights up but heating
temperature is out of control.
The appliance is plugged in, but does
nothing else.
Overload circuit breaker tripped
This appliance is fitted with an automatic overload
circuit breaker.
All manuals and user guides at all-guides.com
Possible causes
1). Thermostat broken
2). Heating element failed
Thermostat failure
Orange indicator broken
Faulty power supply, not properly
plugged in.
• Select the temperature by turning the tempera-
ture control (up to 85ºC) clockwise. Then, orange
indicator lights up.
• Once the set temperature is reached, the orange
indicator will go off automatically.
• Now, you are ready to put the sausages into the
container for heating.
• Risk of splashing! Slowly immerse the sausages
into the water.
• Check the water level regularly during operation.
Add water if the water level below MIN level.
• Allow the appliance & water to cool down.
• Take care when pouring out the water & using
the handles or drain taps (for item 240519 only).
Do not use petrol or solvents! Clean with a damp
cloth and detergent if necessary. Do not use
abrasive materials.
• Clean the ventilation slots (if applicable) with the
vacuum cleaner.
• Regularly descale the bottom of the water con-
tainer.
Possible solutions
Contact the supplier
Contact the supplier
Contact the supplier
Check the power supply system or
plug in properly.
To make the appliance operational again, first al-
low the appliance to cool down, then fill with addi-
tional water.
EN
5