Stihl FS 40 Notice D'emploi page 19

Starting / Stopping the
Engine
Controls
Version with loop handle
3
1
2
1 Throttle trigger interlock
2 Throttle trigger
3 Stop switch with Run and 0 = Stop
positions.
Function of stop switch and ignition
system
The stop switch is normally in the Run
position: Ignition is on in this position –
the engine is ready to start and may be
started. If the stop switch is moved to the
0 position, the ignition is switched off. It
is automatically switched on again after
the engine comes to a standstill.
FS 40, FS 40 C, FS 50, FS 50 C
All manuals and user guides at all-guides.com
Starting the Engine
4
N Press the fuel pump bulb (4) at least
five times – even if the bulb is
already filled with fuel.
Cold engine (cold start)
5
N Press in the choke lever (5) and turn
it to g at the same time.
Warm engine (warm start)
N Press in the choke lever (5) and turn
it to < at the same time.
Also use this setting if the engine has
been running but is still cold.
Starting
N
N
N
5
Place the unit on the ground: It must
rest securely on the engine support
and the deflector. Check that the
cutting tool is not touching the
ground of any other obstacles.
Make sure you have a firm footing.
Hold the unit firmly on the ground
with your left hand and press down
– do not touch the throttle trigger or
interlock lever.
Do not stand or kneel on the drive
tube.
English
17