Samsung HW-H750 Manuel D'utilisation page 26

FUNCTIONS
SOFTWARE UPDATE
+ Updating with USB
Samsung may offer updates for the Soundbar's system
firmware in the future.
If an update is offered, you can update the firmware by
connecting a USB device with the firmware update
stored on it to the USB port on your Soundbar.
Note that if there are multiple update files, you must load
them onto the USB device singly and use them to
update the firmware one file at a time.
Please visit Samsung.com or contact the Samsung call
center to receive more information about downloading
updates files.
1. While the Soundbar is turned off, connect the USB
storage device that contains the updating firmware
to the Soundbar's USB port.
2. Turn on the Soundbar UPDATE appears on the
display and updating begins within 3 minutes.
•
Upon completion of updating, the Soundbar
turns off and on automatically.
If UPDATE was not displayed
1. Turn off the Soundbar, connect the USB storage
device that contains update files to the Soundbar's
USB port.
2. Disconnect the power cord, reconnect it and turn it
on.
All manuals and user guides at all-guides.com
+ Auto update
Even when the Soundbar is turned off, the Soundbar will
automatically check latest software version and continue
to update if it was connected to the Internet.
26
● Updating firmware may not work properly if
audio files supported by the Soundbar are
stored in the USB storage device.
● Do not disconnect the power or remove the
USB device while updates are being applied.
The main unit will turn off automatically after
completing the firmware update.
● After reset, all settings are reset to their
factory default settings. We recommend you
write down your settings so that you can
easily reset them after the update.
Note that updating firmware resets
subwoofer connection too. If connection to
the subwoofer is not established
automatically after resetting, refer to page 13.
If the firmware fails to update, we
recommend formatting the USB device in
FAT16 and trying again.
● Do not format the USB device in the NTFS
format. The Soundbar does not support the
NTFS file system.
● Depending on the manufacturer, some USB
devices may not be supported.
● The Soundbar is configured to run auto
update by default.
● To use auto update function, the Soundbar
must be connected to the Internet.
● Wi-Fi connection to the Soundbar will be
terminated if its power cord was
disconnected or the power was cut off. Turn
on the Soundbar and reconnect.