Motorola CLP Serie Mode D'emploi page 7

All manuals and user guides at all-guides.com
Cloning Radios using the Single Unit Charger (SUC)
1. Unplug any cables (power supply or USB cables) from the Single Unit Chargers.
2. Plug one side of the cloning cable micro connector to one Single Unit Charger. Plug the other
end to the second Single Unit Charger.
Note: During the cloning process no power is being applied to the Single Unit Charger. The batteries are not being
charged. A data communication is being established between the two radios.
3. Turn ON the "Target Radio" and place it facing down into one of the Single Unit Chargers.
4. On the "Source Radio", power the radio following the sequence below: • Press and hold the
Push-to-Talk (PTT) and the "-". Button simultaneously while turning the radio ON until you hear
the Cloning Tone and Double Blinking Yellow
5. Place the "Source Radio" facing down in its Single Unit Charger with an Audio accessory, then
press and release Menu Button to start the cloning process.
6. After cloning is completed, the "Source Radio" sounds either a "pass" tone (cloning was
successful) or a "fail" tone (cloning process has failed). The pass tone sounds like a good key
"chirp" whereas the "fail" tone sounds similar to a "bonk" tone. (A tone is heard in no more than
5 seconds.)
4
English
Cloning Cable HKKN4026_
(Not included)
on the Smart Status Glow.