Publicité
Les langues disponibles
Les langues disponibles
Before starting the Dynamic Heat Control™ installation, remove the safety barrier. Refer to "safety barrier
installation/removal" section in the appliance installation manual.
SINGLE-SIDED MODEL ILLUSTRATED
Front Frame
1.) Remove fasteners securing front frame (and rear
frame for see-thru). Do not discard fasteners.
SINGLE-SIDED MODEL ILLUSTRATED
3.) Remove the fasteners securing the cover plates recessed below the knockout plates. For ease of removal, lift the panel from
below in front of the fi rebox door. Discard cover plates.
IMPORTANT:
Fire Hazard Warning: This step is crucial for your appliance to work properly. If
the knockout plates AND the cover plates are not removed from the access, the
appliance will overheat, the barrier will become excessively hot, and the high
limit switch will constantly trip.
Dynamic Heat Control™ installation
4.0 Dynamic Heat Control™ installation
2.) Remove knockouts plates (FOR SINGLE-SIDED, ONLY REMOVE
THE TWO KNOCKOUTS PLATES ON THE ACCESS SIDE). Discard
knockout plates. Recommended: Use a fl athead screwdriver or a
small pry bar and use prying motion to remove the knockout. Use
a brace such as a piece of wood under the prying tool to avoid distorting
the top
COVER PLATE
Cover Plate
W415-2373 / B / 04.30.21
EN
9
Publicité
