Publicité
Les langues disponibles
Les langues disponibles
fi nish framing - after appliance installation
EN
single-sided recessed
WARNING
!
•
Shaded components (fi nish framing) must be non-combustible materials.
note:
Finish framing must be built after
appliance has been placed in its
fi nal position and venting
connected.
This confi guration also
requires recess area to use
non-combustible facing due to
close proximity to vent.
Installation Option 2 illustrated (appliance not shown)
minimum framing
Ref
K
E
F
53 13/16" (136.7cm)
J
L
Q*
(Q x R)*
M**
* ONLY APPLICABLE TO OPTION 2 AND 3 - Opening must be centered in enclosure on appliance. Dimensions represent
fi nished sizes and where applicable should be adjusted to include fi nish material thickness.
** Can only be increased to 4" max by building a protrusion.
note:
The LV series requires a minimum enclosure height, as illustrated (dimension L), measured from the bottom of
the appliance. For temperature requirements, this area must be left unobstructed. Some venting confi gurations
that require more vertical rise will require a larger enclosure to provide minimum vertical clearance between vent
pipes and combustibles.
18
W415-2373 / B / 04.30.21
Ceiling
J
LV38-1
LV50-2
65 13/16" (167.2cm)
Optional - Appliance does not need to be elevated above fl oor
73" (185.4cm)
80 sq. in.
R
Q
L
M
F
E
LV62
39 15/16" (101.4cm)
20 1/8" (51.1cm)
77 13/16" (197.6cm)
2" min and 3" max
3" (76mm)
K
Drywall
Insulation
LV74
89 13/16" (228.1cm)
91" (231.1cm)
160 sq. in.
Publicité
