Publicité
Les langues disponibles
Les langues disponibles
fi nish framing - after appliance installation
7.0 rough framing - before appliance installation
EN
Before framing your appliance, determine vent requirements before deciding the fi nal location of the appliance.
After rough framing, place the appliance in its fi nal position. Also, see appliance manual for vent shield installation,
nailing tabs installation,electrical installation, gas installation, etc.
single-sided
Ref
E
F
53 13/16" (136.7cm)
J
L
see-thru
Ref
E
F
53 13/16" (136.7cm)
J
L
16
W415-2373 / B / 04.30.21
L
E
F
J
LV38-1
LV50-2
65 13/16" (167.2cm)
Optional - Appliance does not need to be elevated above fl oor
73" (185.4cm)
E
F
LV38-1
LV50-2
65 13/16" (167.2cm)
Optional - Appliance does not need to be elevated above fl oor
73" (185.4cm)
Before framing the appliance, ensure to install
the fi restop fi rst.
LV62
20 1/8" (51.1cm)
77 13/16" (197.6cm)
Before framing the appliance, ensure to install
the fi restop fi rst as it will not fi t between the
studs if installed after framing.
note:
The LV series requires a minimum
enclosure height, as illustrated (dimen-
sion L), measured from the bottom of
the appliance. For temperature require-
ments, this area must be left unob-
L
structed. Some venting confi gurations
that require more vertical rise will require
a larger enclosure to provide minimum
vertical clearance between vent pipes
and combustibles.
J
LV62
16 3/16" (41.1cm)
77 13/16" (197.6cm)
note:
The LV series requires a
minimum enclosure height,
as illustrated (dimension L),
measured from the bot-
tom of the appliance. For
temperature requirements,
this area must be left un-
obstructed. Some venting
confi gurations that require
more vertical rise will require
a larger enclosure to provide
minimum vertical clearance
between vent pipes and
combustibles.
LV74
89 13/16" (228.1cm)
91" (231.1cm)
LV74
89 13/16" (228.1cm)
91" (231.1cm)
Publicité
