Publicité
Les langues disponibles
Les langues disponibles
Maintenance
fireplace to remove (Figure
7).
5.
Pull the front edge of the
plastic ember bed or plastic
grate up and forward until the
rear tab releases from the
ledge located at the bottom
of the partially reflective glass
(Figure 8).
6.
remove flicker rod by sliding
flicker rod to the left away
from the flicker motor and
lifting out.
7.
remove light bracket for
easier access to light bulbs.
!
IMPORTANT: Only handle the
log set by the ember bed.
!
NOTE: Log set fits tightly
into firebox, some force may be
necessary to remove.
8.
Set log set in front of
fireplace.
9.
unscrew bulbs counter
clockwise.
10.
Insert new bulbs.
11.
replace the log set by
inserting the front edge of the
fireplace and push down on
the rear edge of the ember
bed until it snaps into place
(Figure 8).
12.
Lay unit on it's back and slide
16
front glass back into position
and attach trim.
!
NOTE: Ensure the log set is
installed tightly under the back
ledge to prevent light leakage.
Upper Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
15 Watt rating.
Do not exceed 15 Watts per
bulb.
To access the upper light bulb
area:
1.
slide fireplace out of mantel.
2.
Lay unit on it's back for safe
removal of front glass.
3.
Remove four (4) Phillips
screws from right side of trim.
4.
remove trim.
5.
Slide glass to the right side of
the fireplace to remove.
6.
upper bulbs located in the
upper left and upper right
corners of fireplace.
7.
remove upper light block
by removing the four (4)
mounting screws.
8.
unscrew bulbs counter
clockwise.
9.
Insert new bulbs.
www.dimplex.com
Publicité
