Publicité
Les langues disponibles
Les langues disponibles
Operation
Level 2: The flame effect remains
on, the heater is activated to the
low heat setting, and the first and
second red indicator lights flash
momentarily.
Level 3: The flame effect remains
on, the heater is set to the high
heat setting, and all three red
indicators flash momentarily.
Pressing the switch down "II" will
turn the unit off.
!
NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial heating
of internal heater parts and will
not occur again.
Resetting the Temperature
Cutoff Switch
should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset. It
can be reset by switching the on/
off switch to off and waiting five
(5) minutes before switching the
unit back on.
If operating the unit with a remote
control, the remote may require
re-initializing after turning the
power off.
CAUTION: If you need
to continuously reset the
heater, unplug the unit and
call Dimplex north America
Limited at 1-888-346-7539 for
technical support. Please have
your model and serial number
ready when calling.
Remote Control
The fireplace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with one
of hundreds of independent
frequencies to prevent
interference with other units.
Figure 6
ON
Button
OFF
Button
Battery
Battery
Cover
13
Publicité
