Publicité
Les langues disponibles
Les langues disponibles
Fireplace Installation
surface under the fireplace
insert. Ensure that all three of
the insert's feet rest securely
on this surface.
!
IMPORTANT: If not using a
Dimplex mantel, the fireplace
must be installed in an
enclosure with the following
MINIMUM dimensions
(Figure 4).
New Wall Construction
1.
select a suitable location
that is not susceptible to
moisture and is away from
drapes, furniture and high
traffic.
2.
Place the fireplace in the
desired location to see how it
will look in the room.
3.
mark the desired location on
the floor.
4.
Use studs to frame an
opening of 26 ¾" (679 mm)
wide X 23 ⅛" (587 mm) high
X 9" (229 mm) deep.
Option #1: The power cord can
be run from behind the trim and
along the wall to an outlet near
the fireplace.
Option #2: A new outlet can
be installed inside the framing
construction.
10
Figure 4
9"
(229 mm)
Plug the unit into a 15 Amp, 120
Volt outlet. If the cord does not
reach, you may use an extension
cord rated for a minimum of
1875 Watts.
Existing Fireplace
1.
Seal all drafts and vents
with a non-fibrous insulation
material to prevent any
chimney debris from falling
onto the fireplace. Do
not install into an existing
fireplace that is prone to
dampness.
2.
Cap the top of the chimney
flue to prevent rain from
entering.
3.
Plan your electric power
supply.
4.
The power cord can run along
23⅛"
(587mm)
26 ¾"
(679 mm)
www.dimplex.com
Publicité
