Steba BS 1800 Touch Mode D'emploi page 24

difference may depend on many factors including, for example:
- the installation position: some areas of the room may be affected by drafts or hot air sacs that modify the sensor
measurement;
- the fixation to an external wall that, being normally colder than internal walls, may imply the measurement of a tem-
perature lower than the real room temperature;
- a full load of towels on the support bar may obstruct the airflow. As a result the sensor may measure a temperature
higher than the real room temperature;
- unstable conditions: any evaluation must be done in stable working conditions. For this purpose comfort temperature
should be changed only 60min after a previous change . It is not possible, indeed, to evaluate the room temperature
maintained by the product correctly if the comfort level temperature is continually changed in a short time.
If a difference between set temperature and room temperature is detected in stable working conditions, measure the
difference and then increase or decrease the comfort temperature on the product of the exact value of measured
difference.
WEEKLY PROGRAM
The Programmed mode
desired temperature choosing between the Comfort, Eco (equal to that of Comfort decreased by 3.5 ° C) or Antifreeze.
A short press of the button
enter the view/change menu. If the product is brand new the default program is the following:
Always Frost-free mode except Comfort mode in the following hours:
- from 06:00 to 08:00 on Monday-Friday;
- from 08:00 to 10:00 on Saturday-Sunday.
Press the dedicated button to quickly activate the program mode!
To view/change the program proceed as follows:
Press and hold the
08 : 30
The display shows the day 1 (Monday). By pressing the buttons
starting from "00" (hour between 00:00 e le 00:59):
d : 1
The reference temperature set for the selected hour is shown by the Frost-free led (temperature of 7°C), The green
led under the Stand-by button (temperature Eco = Comfort - 3,5°C) or the red led under the Stand-by button (Comfort
temperature set by the user):
H : 00
24
allows to set, for every hour of day and for every day of the week independently, the
allows to activate/deactivate the programmed functioning. A long press (> 3") allows to
button for 3 seconds to enter the menu:
3"
and the different hours of the day are shown
20