Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. l
eDs color
•
There are 3 different led lights on the product:
•
Led light under the frost free button (picture 8, item I)
-
The led is red when the frost free mode is activated. It is switched off when the frost free mode is disabled.
-
Blinks when the Frost free mode was activated by the open window detection function.
•
Led light under the Programmed mode button (picture 8, item J)
-
The led is red when the Programmed mode is activated. It is switched off when the Programmed mode is
disabled.
•
Led light under the stand-by button (picture 8, item K)
The led is red when the product is in the Comfort mode;
-
The led is green when the product is in the Eco mode;
-
-
The led is switched off when the product is in Stand-by.
7. u
sing the Fan heater
MAIN ON/OFF SWITCH
The power supply of the product is controlled by an electromechanical ON/OFF switch. Switching off the fan heater
will cut off the power to the electronic board and this will cause the loss of every stored information, after 30 minutes
of absence of the power supply. We recommend to use this switch only when you are not using the product for long
periods and instead to use the on / stand-by control for any short-term interruptions. In this way you will not lose the
stored settings.
For the first use of the product or in case of power loss for over 30 minutes, when on ON position, the display shows
00:00 and begins counting the time starting from this value.
Should no adjustment be made within 15min after power up, the product will automatically switch in Frost
free mode with the lighting of the corresponding led.
STAND-BY BUTTON
Use this button
to switch ON or put the product in Stand-by mode. The led beneath the Stand-by button will light
on in green color.
00 : 00
00 : 00
SETTINGS
The following keys
,
Comfort temperature and to activate or deactivate the open window detection function.
E.g.: To set 08:30, Wednesday, Comfort temperature of 25°C and disable the open window detection previously set,
proceed as follows:
Press and hold the
button for 3 seconds to enter the settings menu:
00 : 00
and
, will allow you to adjust the current hour and day of the week (1 = Monday), the
3"
17
21
Publicité
Table des Matières
