Concept VR3000 Mode D'emploi page 47

EN
Allow the container and the filters to dry
Sensors and charging poles of the vacuum robot
To ensure proper operation, clean the sensors and charging poles once a week, both on the vacuum robot and
the docking station.
Caution!
Before each cleaning of the appliance, unplug the power cord from the electrical outlet!
To clean the surface of the appliance, use only a damp cloth, no detergents or hard objects, as they can damage
the surface of the appliance!
Clean and inspect the input and output grids of the appliance frequently to ensure good operation of the
appliance and to prevent overheating.
The dust in the appliance can be blown or vacuumed.
Never clean the appliance under running water, do not rinse it or immerse it in water!
CAUTION for cleaning: Do not use gasoline, benzene, thinner, aggressive detergents, etc., as this may damage
the appliance. Never use alcohol or solvents.
92
TROUBLESHOOTING
Problems associated with the function of the appliance, which sometimes may seem serious, can often be solved
easily. Some you can solve yourself with the help of the following troubleshooter. Any further maintenance
should be done at an authorized service centre.
Error
The robot is
charging
The robot is stuck
The robot returns to
the docking station
before completing
the job.
The robot does not
perform cleaning
work as planned.
The remote control
is not working.
(distance up to 5 m)
Note: If none of the above recommended solutions help, try the following:
Turn the main power switch on the vacuum robot ON and OFF again.
Should the problems persist, please contact the service centre.
VR3000 VR3000
Possible cause
1. Contacts on the vacuum 1. Make sure the contacts between the vacuum robot
robot and docking station are and the docking station are connected correctly.
not connected. 2. Allow the robot to charge when it does not work,
2. Docking station if OFF to be ready for the next cleaning.
The robot attempts to free itself automatically. If
The robot has problems with
this is not successful, you have to help the robot
loose cables or carpet fringing.
manually.
1. The robot detected a low
power level and automatically The operating time varies depending on the
returns to be recharged. complexity of the environment, the amount of
2. The robot works differently on waste and the cleaning mode.
different surfaces.
1. The robot was not ON 1. Turn the robot ON
2. The robot had a low energy 2. Allow the robot to charge when it does not work,
level. to be ready for the next cleaning.
3. The robot was stuck in some 3. Turn the robot OFF and clean the dust bin.
obstruction. Make sure the wheels, brushes and sensors are clean.
1. The distance is too large.
2. The robot or the remote control
1. Replace the batteries. Make sure they are in the
is out of energy.
right position.
3. The infra-red beam of the
2. Make sure, the robot is ON and has sufficient
remote control is blocked by
energy to operate.
something.
3. Clean the signal transmitter on the remote control
Obstacle or dirty sensor on the
and the receiver on the robot.
robot's body.
4. Avoid using the remote control near other sources
4. The beam may be affected
of using infra-red signals.
by another device operating on
a similar principle.
EN
Remedy
93