Concept VR3000 Mode D'emploi page 45

EN
Cleaning mode – the ON/OFF button is in the ON position, the vacuum robot operates.
Stand-by mode – the ON/OFF button is in the ON position, the vacuum robot does not operate. To activate it,
press any cleaning mode button.
Sleep mode – the ON/OFF button is in the ON position, the display panel is ON. The vacuum robot enters this
mode automatically after 3 seconds of inactivity.
TIME SETTING
Make sure that the vacuum robot is ON and not charging.
To set the time, press the button on the remote control. First two
digits begin to flash to set the time. To set the values, use the ˄ ˅ buttons.
Press the > button and set the minutes as described above.
CLEANING PLANNING
To set the cleaning mode, press the button on the remote control. At first, two digits begin to flash to set the
time. To set the values, use the ˄ ˅ buttons. Press the > button and set the minutes as described above. Confirm
the time by pressing the (ON/STOP button). The vacuum robot will vacuum each day at the time you have set.
To cancel the scheduled cleaning, press the scheduling button for 3s.
Warning: If you switch the ON/OFF button on the side of the vacuum robot to the OFF position, the scheduling
will be cancelled.
CLEANING MODES
Automatic mode
The vacuum robot uses advanced navigation to calculate the best way to achieve effective cleaning. To activate
this mode, press the button on the vacuum robot body or on
Edge cleaning path mode
To activate this mode, press the button on the remote control. The vacuum robot will vacuum along the
walls where the dust is most often. If you want to cancel this mode, press PAUSE.
88
the remote control.
VR3000
Circular mode
Place the vacuum robot in places where you want to perform a targeted cleaning (approx. area of 1 m
only be controlled by a mobile application.
Single room / Automatic short mode
To activate this mode, press the button on the remote control. The vacuum robot will vacuum for 30 minutes
or if it finishes cleaning in the room. If you want to cancel this mode, press PAUSE.
MOPPING THE FLOOR
If you have a water tank and the mopping cloth installed, activate the mopping mode with the button
Water spontaneously passes through the mopping cloth. The water tank is washable. Always pour the water
only after removing the water tank from the body of the vacuum robot.
When the vacuum cleaner is on, it automatically starts to dispense water into the mop fabric when the water
container is inserted.
Open the sealing cap and
fill with water, close the
sealing cap after filling
BOTTTOM SIDE OF THE WATER TANK
1. Mopping cloth
2. Velcro fastener
3. Water inlets
VR3000
EN
). Can
2
.
1
3
2
89