Publicité
Les langues disponibles
Les langues disponibles
EN
SIDE VIEW
1.
Power socket
2.
ON/OFF button
3.
Dust bin button
DUST BIN
1.
Primary filter
2.
HEPA filter
3.
Foam filter
4.
Dust bin
5.
Dust bin Cover
DOCKING STATION
1.
Signal light
2.
Power supply socket
3.
Charge connecting points
Magnetic strip
Place a magnetic strip in places, where you
do not want the vacuum cleaner to enter.
86
3
1
2
3
Remote control
1.
1
2.
3.
4.
2
5.
6.
7.
1
8.
9.
10. Mopping mode
11. Plan button
2
12. Edge cleaning path mode
3
4
Warning:
5
If the vacuum robot is near the docking station and a virtual safety wall, it is possible that it will not recognise the
instructions issued by the remote control If you do not use the remote control for a long time, remove the batteries.
After pressing and holding the "up" button on the remote control, the vacuum cleaner will go straight. If you
release the button, the vacuum cleaner will not stop, but will continue to run until it hits something.
BEFORE FIRST USE
1.
Insert the batteries into the remote control.
2.
Apply the cleaning brushes as indicated by R and L.
3.
Connect the charging base to an electrical outlet using the AC adapter. Place the charging base against the
wall and remove obstacles about 1 meter at two sides and 2 meters forward. The indicator light must light
up when connecting to a mains power supply. It is recommended to fix the charging base to the floor, e.g.
by double-side mounting tape. Place the power supply cable so to avoid tangling of the vacuum cleaner.
4.
Place the vacuum robot onto the charging base.
5.
The vacuum robot battery will start charging automatically. Allow the battery to charge for more than
12 hours before first use. During charging, the indicator light between the ON and OFF buttons flashes,
it stops flashing after the battery is fully charged. If the battery is near the discharge point, the vacuum
cleaner will automatically search for the charging base.
6.
Before using the vacuum robot, please remove any objects from the floor that can prevent the vacuum
robot from operating (cables, chairs, small items, inappropriately placed carpet, etc.)
VR3000
VR3000
ON/OFF button
Display screen
Home
Automatic mode
ON/STOP button
4
Directional buttons
Suction power button (TURBO)
TIME SETTING
5
30 minutes mode / single room
7
10
11
1 m
1 m
2 m
EN
1
2
3
6
8
9
12
87
Publicité
