Joie juva Manuel D'utilisateur page 10

Handle Adjustment
see images -
5 6
The handle of the infant child restraint can be adjusted to 3
positions.
5
Position 1 Position for car, hand or stroller transportation.
Position 2 Rocking position.
Position 3 Baby chair position.
To adjust the handle, squeeze handle buttons on both sides to
release it -1, and then rotate the handle until it clicks into any
6
of the 3 positions. -2
6
Shoulder Harness Position
see images -
7 8
Check that shoulder harnesses are set at the proper height.
Please choose the proper pair of shoulder harness slots
according to the child's height.
!
Shoulder harnesses must go into the harness slots nearest to
your baby's shoulders
!
If the shoulder harnesses are not at proper height, the child
might be thrown from the infant child restraint when there is
an accident.
7
, but not above the shoulder line.
7
Shoulder Harness Height
Adjustment
see images -
9
1. Press the adjustment button at the front of the seat and pull
the shoulder harnesses to loosen them.
2. At the back of the seat, take the harness ends off the metal
junction plate.
10
3. Pull the harnesses through the slots in the seat
then insert them into the appropriate set of slots.
a. Thread the shoulder strap through shoulder harnesses.
b. Thread the shoulder harness anchor through the shoulder
harness slot.
c. Thread the shoulder strap through the shoulder harness
slot.
4. Reassemble the harness ends onto the junction plate.
!
Thread the shoulder strap through the shoulder harness
-1
anchor.
12
!
8
The shoulder harnesses must be placed in back of the two iron
tubes.
!
During adjustment, make sure the shoulder harnesses are not
twisted.
!
Use extreme care in threading the shoulder harnesses
according to the figure. If the shoulder harnesses are not
secure, they will not protect your baby properly.
12
9
-1, and
11
-2
11
12
8