Publicité
Les langues disponibles
Les langues disponibles
•
Offer this assembly up to frame mount and tighten bolt until you feel some compression from
inside the protector using a 17mm socket and wrench. PLEASE NOTE THE CRASH
PROTECTOR MUST BE POSITIONED AS IN PICTURE 'C' ABOVE WITH BIGGER
END TOWARD FRONT OF BIKE. Turn a little more so that you feel the compression increase
slightly. Then apply a quarter turn. Do not over-tighten as damage can occur to the bike. Do not
exceed 40nm of torque.
Page | 4
•
If not already fitted fit bubble sticker into recess of the crash protector cap (item 1).
•
Fit the crash protector cap into the crash protector.
Publicité
