Kasanova E-MOOTIKA Manuel D'instruction page 63

All manuals and user guides at all-guides.com
E-MOOTIKA
INSTRUCTION MANUAL
ENG
63
4.1.2. Charging steps and method
1. Check carefully whether the rated input voltage of the charger is
consistent with the voltage of the power grid.
2. The battery can be directly put on the bike for charging and can
also be taken down from the bike to be charged indoors and at other
appropriate places.
3. Connect first the output plug of the charger with the charging
jack of the battery properly, and then connect the input plug of the
charger to the AC power supply.
4. At this time, the power indicator light and the charge indicator
light of the charger are on, indicating that the charging has been
connected.
5. After charging, should first pull out the AC power plug, and then pull
out the plug connected with the battery.
After the battery is fully discharged, the one-time charging time is
6 to 8 hours, and after the charge indicator light is red from green,
the power capacity of the battery has been basically sufficient.
A new bike had best be re-charged for (8 to 9 hours) after depth
discharging since charging for the first time, and the one-week
depth charging and discharging is a cycle to fully activate the active
substances inside the battery. Later, it can be re-charged even if its
power is not used up.
Common sense of charging and use:
- The battery should be charged in a spacious environment, staying
away from high temperature, high humidity and close fire, because
the battery and the charger are electronic products, high
temperature and humidity will corrode electronic components, resul-
ting in some harmful gases and soot, and even a possible
explosion to wound.
- The charging time should not be too long. A long charging will
lead to shortened life expectancy of the battery.
- After the battery is fully charged, the power supply should be