Black & Decker LSWV36 Mode D'emploi page 8

Sweeper MOde aSSeMBLy
NOTe: Ensure the sweeper is switched off and the battery is
removed before attaching or removing the sweeper tubes. The
tube assembly must be assembled to the housing before use.
• TUBe aSSeMBLy:
To attach the two piece
sweeper tubes to the
sweeper, line up the tube
with the sweeper housing
as shown in figure d. Push
the tube into the sweeper
housing until the lock lever engages the
lock hole in the tube.
• faN cOVer aSSeMBLy: To attach the
fan cover to the sweeper, line up the tabs
on the cover with the sweeper housing
slots as shown in figure d1. Push the
cover into the sweeper housing until the
locking/release button is fully engaged.
(This comes pre-assembled from the factory).
VACUUM MODE ASSEMBLY
COLLECtiOn BAg (FigURE E)
• Remove sweeper tube if attached.
• Push the collection bag on to the
sweeper housing until the lock lever
engages the lock hole as shown in
figure E.
• Attach collection bag clip to the lower
rear of the unit as shown in figure E1.
All manuals and user guides at all-guides.com
D
D1
E
E1
VACUUM tUBE ASSEMBLY
(FigURES F, g, H, H1)
NOTe: Ensure the sweeper is switched
off and the battery is removed before
attaching or removing the vacuum tubes.
The vacuum tube and collection bag must
be assembled to the housing before use.
• Vacuum tubes must be assembled
together before use.
• Align the notches and the triangles on
upper and lower tubes. (figure F)
• Push the lower tube firmly into the
upper tube, until the triangles click into
place. (Never operate apart).
• In the interest of safety, it is not
intended for the tubes to be separated
once assembled.
• Remove the fan cover from the side of
the sweeper housing by pressing the
spring loaded release button (located
on the lower right side of the sweeper
housing) and pulling the cover off
(figure g). Fan cover can be stored in
pouch on collection bag.
• Attach the vacuum tube assembly to
the fan inlet on the sweeper housing
(figure H) by lining up the tabs on the
tube with the slots on the sweeper
housing and push inwards until the
locking/release button is fully engaged.
(figure H1)
• Vacuum tube assembly can be stored
by hanging on a wall with a nail, using
the built in hang hole on the underside
of the tube.
8
F
G
H
H1