Mounting Precautions (For Sharp Dealers And Service Engineers) - Sharp Aquos Board 4T-B70CT1U Guide De Configuration

(For SHARP dealers and service engineers)
• When installing, removing or moving the monitor, ensure that this is carried out by at least 2
people.
• Be sure to use a wall-mount bracket designed or designated for mounting the monitor.
• This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might
be necessary for some materials such as plaster / thin plastic board / wood before starting
installation.
• This monitor and bracket must be installed on a wall which can endure at least 4 times or
more the weight of the monitor.
Install by the most suitable method for the material and the structure.
• To attach a VESA-compliant mounting bracket, use M6 screws that are 25/64 inch (10 mm)
longer than the thickness of the mounting bracket.
• Do not use an impact driver.
• When moving the monitor, be sure to hold the parts marked by
Do not grasp the screen.
This may cause product damage, failure, or injury.
• If you need to temporarily place the monitor on a table or other surface during installation,
spread a thick soft cloth on the table to prevent damage to the screen and table.
• After mounting, please carefully ensure the monitor is secure, and not able to come loose
from the wall or mount.
• Do not use any screw holes other than those for mounting brackets, located on the rear of
the monitor, for installation.
Mounting Precautions
25/64 inch (10 mm)
Screws (M6)
Mounting bracket
Monitor mounting
[4T-B70CT1U]
- 5 -
below.