Siemens Bewator BM3 Manuel D'installation Et Utilisation page 18

All manuals and user guides at all-guides.com
18
Erasing access codes
To erase a programmed access code:
1� Set Bewacom to programming mode.
2� Enter the access code to erase.
3� Enter 0000.
4� Enter 0000 again.
5� Press B.
6� Press B to exit programming.
Changing the door unlock time
When Bewacom is delivered the door unlock
time is set to 7 seconds.
1� Set Bewacom to programming mode.
2� Press A28.
3� Select the required unlock time in seconds
(01-99).
4� Press B to exit programming.
Extending the opening time 10 times
Using this function the door unlock time can be
increased by a factor of ten.
1� Set Bewacom to programming mode.
2� Press A64.
BM3 Installation & User Manual