Siemens Bewator BM3 Manuel D'installation Et Utilisation page 16

All manuals and user guides at all-guides.com
16
Programming access codes (first time)
Four different 4-digit entrance codes can be
programmed.
1� Set Bewacom to programming mode.
2� Press 0000.
3� Enter the desired access code using 4 dig-
its.
4� Enter the code once again.
5� If the code is not to be time controlled,
press 0.
If the code is to be time controlled, select
the desired input (see below).
1 = the code can be timed from a time clock
connected to input 1.
2 = the code can be timed from a time clock
connected to input 2.
Also see the wiring diagram.
6� Follow steps 2-5 to programme the next
code.
7� Press B to exit programming.
BM3 Installation & User Manual