Siemens Bewator BM3 Manuel D'installation Et Utilisation page 15

All manuals and user guides at all-guides.com
BM3 Installation & User Manual
Setting a password
The first thing to do is to set a password. You
will later use the password each time you want
to programme the Bewacom.
1� Open the Bewacom and turn it around so
the circuit board can be seen.
2� Press the SW1 button (see the wiring dia-
gram).
3� Enter the desired 6-digit password. mm
4� Make a note of the password and store the
note in a safe place.
Setting Bewacom to programming mode
To programme a function, set Bewacom to pro-
gramming mode.
1� Press and hold the B button on the Bewa-
com keypad until the beeper goes off an the
yellow LED goes out (approx 3 seconds).
2� Enter the 6-digit password.
15
ll
ll