Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Attaching the guard
1. Place the angle grinder on a work bench,
groove facing up.
2. Bring the flange of the guard (3) collar
over the groove (11) of the gear housing.
3. Turn the guard (4) counterclockwise by
150 degrees.
4. Make sure that the screws (20) are
tightened.
Removing the guard
1. Loosen the screws (20) on the guard
collar.
2. Pull up the guard (3).
Warning: Do not operate the tool
when the safety guard is not in
place.
Fitting and removing a grinding (Fig. C1,
C2, C3)
Warning: Do not use damaged
grinding wheels.
1. Place the tool on a work bench, guard
up.
2. Fit the inner flange (6) correctly onto the
spindle (7)
(Fig. C1).
3. Place the disc (8) on the flange (6)
(Fig.C2). When fitting a disc with a
raised center, make sure that the raised
centre (9) is facing the flange (6).
4. Screw the out flange (10) onto the
spindle (7) (Fig. C3)
- the ring on the flange (10) must fae
towoards the disc when fitting a
grinding disc (A)
- the ring on the flange (10) must face
away from the disc when fitting a
cutting disc (B)
5. Press the spindle lock (2) and rotate the
spindle (7) until it locks in position
(Fig. C2).
6. Tighten the flange (10) with the two-pin
spanner supplied.
10
(Original instructions)
7. Release the spindle lock.
8. To remove the disc, loosen the flange
(10) with the two-pin spanner.
Warning: Do not use a damaged disc.
Mounting the side handle (Fig.D)
• For grinding, screw the side handle (4)
tightly into one of the holes (11) or (12)
on either side of the gear case.
Preparation Before Use
• Attach the safety guard and appropriate
abrasive or grinding wheels. Do not use
abrasive or grinding wheels that are
overly worn.
• Make sure that the inner and outer
flanges are attached correctly.
• Make sure that the abrasive or grinding
wheels are rotating in the direction of the
arrows on the accessories and tool.
Operation (Fig. F)
Instructions
Warning: Always observe the safety
instructions and applicable
regulations.
Warning: To minimize the danger of
serious personal injury, please
switch o
the tool power and
disconnect all plugs before adjusting or
removing /installing any accessory. Before
reassembling the tool, press and release the
trigger switch to make sure the tool is
already switched o .
Warning:
• Make sure all materials to be grinded are
secured in position.
Use clamps or a vice to hold and support
the workpiece to a stable platform. It is
important to clamp and support the
workpiece securely to prevent the
movement of the workpiece and loss of
control. Movement of the workpiece or loss
of control may create a hazard and cause
personal injury
Publicité
