Electrolux XLCE Notice D'utilisation page 22

Installation
General Installation
1. Connect the exhaust duct to the outside exhaust system.
Use of a 100 mm clamp is recommended to connect the
dryer to the exhaust vent system. Use metal foil tape to
seal all other joints.
2. Carefully slide the appliance to its fi nal position. Adjust one
or more of the legs until the unit is resting solidly on all four
legs. Place a level on top of the washer. The unit MUST be
level and resting solidly on all four legs. Rock alternating
corners to check for stability.
IMPORTANT:
Be sure the power is off at a circuit breaker/fuse box before
plugging the power cord into an outlet.
3. Plug the power cord into a grounded outlet.
4. Turn on the power at the circuit breaker/fuse box.
5. Read the Use & Care instruction at the beginning of this
guide. It contains valuable and helpful information that will
save you time and money.
6. If you have any questions during initial operation, please
review the "Avoid Service Checklist" before calling for
service.
7. Place these instructions in a location near the laundry cen-
ter for future reference.
NOTE
A wiring diagram and technical data sheet are located behind
the dryer access panel.
22
All manuals and user guides at all-guides.com
CLAMP